Note: When drilling holes for screws, make sure to coat the drill bit with grease to catch the shavings.įigure 1. Failure to drill the hole straight could result in damage to the seal bore, resulting in the replacement of the front cover housing. When drilling pilot holes for the removal of the seal ensure that the drill is straight and perpendicular to the seal. Check the seal for wear at the places where it contacts the crankshaft.Refer to "1.12.1 Crankshaft Vibration Damper Removal" Remove the vibration damper from the engine through the opening in the bumper.Push the support angle bracket fairing down to create an opening in the bumper. From underneath the front of the engine, remove the bumper beam.To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. Park the vehicle on a level spot, set the parking brakes, and chock the tires.Remove the front radial seal as follows: Two Kent-Moore tools are required for this procedure:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |